| Learning to get enough height to start grinding | | | | of the plywood into the 2"x4"x3' boards. |
| and stalling can be a real challenge for the | | | | The finishing nails are nailed into the board about |
| beginning BMX biker. Here is something that can | | | | ½" to ¾" The nails provide a place for |
| be built and used to get the heights needed. The | | | | the plastic pipe to hang. You can put the nails 1" |
| best part about it that it is cheap and easy to | | | | apart going up on each side. |
| build. Materials can found at your local lumber | | | | Using the Bunny Hop Trainer. |
| hardware store. The materials needed are as | | | | Set the trainer in the middle of the area you are |
| follows; | | | | going practice. Set the pipe on the lowest nail to |
| 2-2"x4"x3'board | | | | get use to it. Start from the opposite side where |
| 1-1/2"x8' piece of hard plastic water pipe. | | | | the pipe hangs and ride towards the pipe and hop |
| 20-2" finish nails. | | | | over it. If you hit the pipe it will simply fall off the |
| 1-3/4"x1'x4' plywood | | | | hanger. When you clear the pipe with ease raise it |
| 4-3"deck screws | | | | another 1". |
| With the materials assemble as the diagram | | | | You will find after using the Bunny Hop Trainer |
| illustrates. | | | | your grinding and stalls will be easier at the Skate |
| "You can see the detailed picture at under articles | | | | Park or street riding. You can amaze your BMX |
| page". | | | | and skateboarding hombres with your new |
| The 3" deck screws come up from the bottom | | | | learned skills. |